Short answer: Removing a driveway in Jacksonville means saw-cutting the slab free from the street apron, garage floor and walkways, breaking it up, hauling it off (clean concrete is usually recycled) and grading the base for whatever comes next. National cost guides put a concrete driveway removal at about $1,000 to $2,500. If any part of the job touches the City right-of-way, such as the driveway apron or the public sidewalk, the City of Jacksonville requires a Right-of-Way permit, applied for through JaxEPICS by a bonded contractor.
This guide explains driveway removal in Jacksonville from start to finish: where your property ends and the City’s right-of-way begins, the permit rules that apply to aprons and sidewalks, published cost ranges for concrete and asphalt, and what happens to the debris. Arwood Site Services of Jacksonville removes driveways, sidewalks, patios and slabs, including partial removals cut out for repairs.
What does driveway removal involve?
Every driveway is a little different, but most Jacksonville removals include the same pieces of work:
- Saw-cutting: clean cuts where the old driveway meets anything that stays, such as the garage slab, a walkway, the curb or a section you are keeping.
- Breaking out: heavy equipment breaks the slab into pieces. Reinforced concrete (rebar or wire mesh) takes longer to break than plain concrete.
- Loading and hauling: broken concrete or asphalt is loaded into trucks and taken to a recycler or disposal facility.
- Base work: the subgrade is cleaned up and graded so it is ready for a new pour, pavers, gravel or sod.
- Apron and sidewalk sections: any work between your property line and the street is handled under a City Right-of-Way permit (see below).
The same process applies to old sidewalks, patios and slabs. HomeAdvisor notes that sidewalks and patios are usually 3 to 4 inches thick, while driveways often run 4 to 6 inches and may be reinforced, which is one reason driveways can cost more to remove (HomeAdvisor, updated June 20, 2026).
Is my driveway apron in the City right-of-way?
Often, part of it is. The apron is the section that connects your driveway to the street. In many neighborhoods the apron, the public sidewalk and the swale sit between your property line and the road, on City right-of-way rather than on your lot. Your property survey shows where your lot line actually falls.
That line matters because the City of Jacksonville requires a written Right-of-Way (ROW) permit to “disturb, excavate, block, obstruct, tamper with or place any construction or other material on or in” a City road, right-of-way or easement. The City notes the ROW permit is sometimes called a driveway permit (Section 744.110, Ordinance Code; City of Jacksonville Right of Way Permitting).
A City ROW permit is not needed when the work is in a Florida Department of Transportation right-of-way (a state road, which has its own FDOT permit process), on a private road or in an easement the City does not control, such as a JEA easement (Do I Need a Right of Way Permit?).
What are Jacksonville’s Right-of-Way permit rules for driveways and sidewalks?
These points come straight from the City’s Development Services pages, checked November 12, 2026:
- Apply online in JaxEPICS. All ROW permit applications are submitted and reviewed through JaxEPICS.
- The contractor must be bonded. With few exceptions, a ROW permit cannot be applied for or issued unless the contractor has a current Right-of-Way surety bond on file with Development Services. The City publishes a residential ROW bond form specifically for residential driveway repair and construction.
- Two sets of drawings. The application needs drawings showing where the work is, tied to reference points such as the road centerline, right-of-way line or property line, with relevant elevations.
- Replacing what’s there is simpler. Replacement of existing pavement (driveway, sidewalk, curb and gutter) does not need a field review; the permit is issued upon payment. New pavement construction in a subdivision five or more years old goes to a City field inspector for review first.
- Pavers in the right-of-way need an extra step. The City treats brick pavers, landscaping, walls and similar items in the right-of-way as “nonstandard construction.” The owner must get a Revocable Permit, accepting liability and maintenance, before the ROW permit is submitted (Non-Standard Construction).
- Traffic and inspections. Work or equipment that affects vehicle or pedestrian traffic needs an approved Maintenance of Traffic (MOT) plan, and the contractor schedules inspections on the permit.
- Permits last six months. Most ROW permits are valid for six months once approved, with a six-month extension available on request.
Fees: The City’s published fee for a Residential R/W Permit is $127.00. Fees are automatically doubled if construction starts in the right-of-way before a permit is issued (City of Jacksonville City Fees, Construction in Right-of-Way Permits). The City also states that working without a required permit can bring a fine of up to $250 or up to ten days in jail, or both, with each day counted as a separate offense.
Who should pull the permit? The City warns that whoever pulls the permit is liable for the work, and that a contractor asking you to pull the permit for them may not be bonded. If you do the work yourself, you are considered the contractor and must meet every requirement, including the bond.
For driveway work that stays entirely on your own lot, ask the City’s Building Inspection Division whether your specific project needs a building permit. National guides note that small, non-structural concrete removal often does not, but the City makes the call.
How much does driveway removal cost in Jacksonville?
We did not find a published, Jacksonville-only average, so the figures below are published national and regional guide ranges, not an Arwood Site Services price list. Your written quote depends on size, thickness, reinforcement, access and how much right-of-way work is involved.
| Item | Published range | Source |
|---|---|---|
| Concrete driveway removal | $1,000–$2,500 (HomeAdvisor); $1,500–$2,500 (Fixr) | HomeAdvisor; Fixr |
| Concrete removal, any project | $542–$1,744, average $1,139 | HomeAdvisor |
| Concrete removal per square foot | $2–$6 | HomeAdvisor; Fixr |
| Unreinforced vs. reinforced concrete | $2–$4 vs. $4–$6 per sq. ft. | Fixr |
| Urban-area rate, Southeast region | $6–$10 per sq. ft. | HomeAdvisor |
| Concrete sidewalk removal | $900–$2,500 (HomeAdvisor); $1,200–$2,200 (Fixr) | HomeAdvisor; Fixr |
| Concrete patio removal | $1,000–$2,000 | HomeAdvisor; Fixr |
| Asphalt removal per square foot | $1–$2 (HomeAdvisor); $3–$7 average (Angi) | HomeAdvisor; Angi |
| Asphalt driveway, 20 x 20 ft (400 sq. ft.) | $1,200–$2,800 | Angi |
| Adding a driveway apron | $1,300–$7,800 | Angi |
| City Residential R/W permit (if apron or sidewalk is involved) | $127.00 | City of Jacksonville |
To ballpark a concrete driveway, multiply length by width for square feet, then apply the per-square-foot range. HomeAdvisor’s table puts a 400-square-foot slab at $800 to $2,400. HomeAdvisor also says reinforced concrete can cost 50% to 100% more to remove than plain concrete.
What happens to the old concrete and asphalt?
- Clean concrete can be recycled. Florida defines “clean debris” to include uncontaminated concrete, even with embedded pipe or steel, and state rules allow clean debris to be used as fill or raw material (Florida Administrative Code 62-701.200 and 62-701.730). The Florida DEP lists crushed concrete for road construction and drainage among common recycled uses (FDEP C&D recycling options).
- Asphalt is C&D debris. Florida’s definition of construction and demolition debris specifically includes concrete and asphalt material.
- Landfill is the costly option. The City’s published rate for construction and demolition debris generated inside Jacksonville is $22.71 per ton at City disposal facilities with scales (Section 380.303, City Fees). Concrete is heavy, so tonnage adds up quickly.
- Our approach: Arwood Site Services of Jacksonville takes removed concrete to a recycling facility, where it is crushed and reused as aggregate, instead of sending it to a landfill.
What are the steps in a Jacksonville driveway removal?
- Site visit and written quote. We measure the driveway, check thickness and access, and note any apron, sidewalk or curb sections in the right-of-way.
- Permits. If the apron or sidewalk is involved, a bonded contractor applies for the City ROW permit in JaxEPICS with the required drawings.
- Call Sunshine 811. Florida law treats demolition as digging. A locate ticket must be submitted at least two full business days before work starts, not counting weekends and holidays (Sunshine 811 FAQs). Point out private lines, such as sprinklers or landscape lighting, which 811 member utilities may not mark.
- Saw-cut and break out. Clean cuts protect the garage slab, walkways and the curb, then the driveway is broken up.
- Haul and recycle. Debris is loaded and taken to a recycler whenever the material allows.
- Grade and inspect. The base is graded for the next surface, and any required City inspection on the ROW permit is completed.
How can you keep driveway removal costs down?
- Move vehicles, planters and basketball goals before the crew arrives so equipment has clear access.
- Decide what is staying. A partial removal of the cracked or sunken section can cost less than tearing out the whole driveway.
- Bundle nearby concrete, such as an old patio, walkway or slab, into the same visit. If a pool is coming out too, see our swimming pool removal page.
- Ask whether the quote includes hauling, disposal or recycling, base grading and the ROW permit.
- If you plan pavers in the apron, start the City Revocable Permit early so it does not hold up the schedule.
Frequently asked questions
Do I need a permit to remove my driveway in Jacksonville?
If the work touches the City right-of-way, yes. Replacing an apron or public sidewalk needs a City Right-of-Way permit through JaxEPICS. For work entirely on your own lot, confirm with the City’s Building Inspection Division.
How much is a driveway permit in Jacksonville?
The City’s published Residential R/W permit fee is $127.00. It doubles if work in the right-of-way starts before the permit is issued.
Can a homeowner pull a right-of-way permit?
Only by acting as the contractor. The City says an owner doing the work must meet all contractor requirements, including a Right-of-Way surety bond on file.
How long does it take to remove a driveway?
HomeAdvisor says most concrete demolition wraps up in a single day with the right crew and equipment. Larger or reinforced slabs take longer. Add two full business days for the Sunshine 811 ticket, plus permit time if the apron is involved.
Can I put pavers in my driveway apron?
Possibly, but the City treats pavers in the right-of-way as nonstandard construction. You need a Revocable Permit, accepting liability and maintenance, before the ROW permit is submitted.
Is concrete from a driveway recycled?
Clean concrete usually can be. Florida rules treat uncontaminated concrete as clean debris that may be reused as fill or raw material, and Arwood Site Services takes it to a recycling facility.
Does asphalt cost less to remove than concrete?
Published guides disagree. HomeAdvisor lists asphalt removal at $1 to $2 per square foot versus $2 to $6 for concrete. Angi lists asphalt at $3 to $7 per square foot on average. Thickness and the gravel base underneath drive the price.
Get a free driveway removal quote in Jacksonville
Planning a new driveway, a wider apron or a cleaner yard? Arwood Site Services of Jacksonville will look at your driveway, sidewalk or patio, explain what needs a City permit and give you a written quote.
- Call (904) 305-7534
- Email [email protected]
- Request online: Get a Quote
Learn more on our Driveway Removal page.
Sources
- City of Jacksonville, Right of Way Permitting (updated 10/2026)
- City of Jacksonville, Do I Need a Right of Way Permit? (updated 8/4/2026)
- City of Jacksonville, Non-Standard Construction
- City of Jacksonville, City Fees (Construction in Right-of-Way Permits; Section 380.303)
- JaxEPICS
- HomeAdvisor, How Much Does Concrete Removal Cost in 2026?, updated June 20, 2026
- HomeAdvisor, How Much Does It Cost to Repave a Driveway?, updated June 20, 2026
- Fixr, How Much Does Concrete Removal Cost?, updated January 31, 2025
- Angi, How Much Does Asphalt Removal Cost? [2026 Data], updated Oct. 22, 2026
- Fla. Admin. Code R. 62-701.200, Definitions and R. 62-701.730, C&D Debris Disposal and Recycling
- Florida DEP, Construction and Demolition Debris Recycling Options and Tips
- Sunshine 811, FAQs and When Can I Dig?
Cost figures are published national and regional guide ranges from the sources above, checked November 12, 2026. They are not quotes from Arwood Site Services. City rules and fees were checked on jacksonville.gov the same day; confirm current requirements for your address before work begins.
Planning a demolition cleanup? See our Jacksonville roll-off dumpster guide for container sizes, right-of-way placement permits and published costs.





